Using Bubba|Two as a LAN only server, not connecting the WAN port, demands that you use DHCP to configure the LAN IP adress.
Manually configuring the LAN IP address, do not allow manually configuring the gateway and DNS server, making it impossible to use filedownload, webmail or even the update service. When using an externally DHCP server placed on the LAN to supply IP addresses, the gateway and DNS server are correctly set up (via the DHCP options), and the mentioned services works fine.
I would be nice if it was possible to make a "disables" selection on the WAN interface, and then make it possible to supply gateway and DNS server on the LAN interface - the entry fields are already on the LAN settings page, just grayed out and used for information only.
Please note the new address for this forum : forum.excito.org. The old address redirects here but I don't know for how long. Thanks !
New user's registration have been closed due to high spamming and low trafic on this forum. Please contact forum admins directly if you need an account. Thanks !
Using Bubba|Two as LAN only server - disabling WAN
Re: Using Bubba|Two as LAN only server - disabling WAN
We are currently working in the interface to allow such configuration.JC wrote:Using Bubba|Two as a LAN only server, not connecting the WAN port, demands that you use DHCP to configure the LAN IP adress.
Manually configuring the LAN IP address, do not allow manually configuring the gateway and DNS server, making it impossible to use filedownload, webmail or even the update service. When using an externally DHCP server placed on the LAN to supply IP addresses, the gateway and DNS server are correctly set up (via the DHCP options), and the mentioned services works fine.
I would be nice if it was possible to make a "disables" selection on the WAN interface, and then make it possible to supply gateway and DNS server on the LAN interface - the entry fields are already on the LAN settings page, just grayed out and used for information only.
/Carl
