Hi,
I have had the bubba two for a while now and i have been running it with a 200 Gb maxtor drive. Now as i try to upgrade to a WD-GP-750 (supposedly supported) i get in trouble.
The disk passes fine when i use SMART to check it and I can use it in my desktop.
When i try to install the bubba system on it though the bubba behaves a little strange.
I connect power, holding the power button until it flashes 4 Hz than 0-5 seconds more (i have tried many ways).
The bubba flashes for a little while, first 4 Hz, then after just a few secons, ~1 Hz then it is lit for about 2-5 seconds and then it shuts of.
When I put the drive back in my computer the partitions are all messed up.
Any ideas?
Please note the new address for this forum : forum.excito.org. The old address redirects here but I don't know for how long. Thanks !
New user's registration have been closed due to high spamming and low trafic on this forum. Please contact forum admins directly if you need an account. Thanks !
Problem with fresh install on WD-GP-750 [SOLVED]
Re: Problem with fresh install on WD-GP-750 [SOLVED]
It seems like i didn't hold the button long enough. Now last time I held it for a good 10s after the light started flashing at 4Hz.
Still flashing now!
*fingers crossed*
Still flashing now!
*fingers crossed*