Re-install problem Bubba2

[mhj]

Hi
I have bought a USB stik to re install my Bubba2,
but I have completely lost connection to the server.
The re install process works fine in the start- the blue LED flashes with 4 kHz and the
USB device begins to install (it lights up and flashes).
It goes on for 4-5 min. then the LED light begins flashing with 1 kHz
- and I can not get in contact with the server.
I have tried several times, trying to put the server directly into my
Telia modem or my wireless routes, but it gives the same result
Some good experience / advice for a very frustrated man?

Regards
Martin

[Cheeseboy]

Hi,

It is quite sensitive to how the file systems/partitions on your usb-stick are configured. I had to try several physical usb-devices before it worked, even though the partition table looked the same on all of them. I just found one that worked in the end. I know it doesn't make sense, but it seems there is some fairy magic involved in the bubba boot-sticks.

Sent from my HTC Desire using Tapatalk

[jonjon649]

I couldn't get anything to work, not usb sticks, nor usb hard drives. Eventually got a usb hard drive to work (formatted it on windows 7 using acronis disk director), created two partitions on it, just to ensure that I was actually creating a partition table. Don't know if that made any different or not.