Hallo,
After connecting a USB Printer with my new Bubba 2 I get (not always, but most of the time) the error message (dmesg) "Cannot enable port 2. Maybe the USB Cable is bad?" and "unable to enumerate USB device on port 2"
I have tried another USB cable but the error remains the same.
If I connect the printer to an other computer it works fine.
Is it problem of the hardware?
Please note the new address for this forum : forum.excito.org. The old address redirects here but I don't know for how long. Thanks !
New user's registration have been closed due to high spamming and low trafic on this forum. Please contact forum admins directly if you need an account. Thanks !
Cannot enable port
-
RandomUsername
- Posts: 904
- Joined: 09 Oct 2009, 18:49
Re: Cannot enable port
Have you tried both USB ports in the Bubba?
Re: Cannot enable port
I have tried both USB Ports, I have tried to connect via a USB Hub.
-
RandomUsername
- Posts: 904
- Joined: 09 Oct 2009, 18:49
Re: Cannot enable port
It does sound like your Bubba might be dodgy. What model is the printer?
Re: Cannot enable port
The printer is an old Oki B4250.
After rebooting the bubba printing works fine for one day. But now I get the same errors again.
After rebooting the bubba printing works fine for one day. But now I get the same errors again.