My Bubba|2 WiFi is also my router & firewall connected to broadband cable modem and I'm setting up vnstat which shows data for eth0 and complains there's not enough data to show eth1 (command line vnstat).
Using netstat -i it looks like devices br0 (apparently aka wlan0) and eth0 are in fact the internal and internet network devices - not eth0 and eth1 according to the Excito Wiki (on setting up vnstat). Device eth1 is listed but with negligable traffic, so I presume that vnstat should be set up to monitor eth0 for internet and br0 (or wlan0) for internal/wireless lan, which I have now done.
I'm not confident enough to update the Wiki on this so thought it best to post here. If you know about the other devices listed by netstat -i please describe in a follow up.
Mark
Please note the new address for this forum : forum.excito.org. The old address redirects here but I don't know for how long. Thanks !
New user's registration have been closed due to high spamming and low trafic on this forum. Please contact forum admins directly if you need an account. Thanks !
Setting up vnstat for Bubba|2 WiFi
-
theWebalyst
- Posts: 96
- Joined: 27 May 2010, 14:53
Re: Setting up vnstat for Bubba|2 WiFi
If your box is built as a standard config, the eth0 is your external interface, eth1 is your internal LAN interface and br0 is the WiFi interface.
If you are only using WiFi, then I would expect eth1 to have virtually no traffic.
I would set up monitoring on br0 as well for a while using my how-to as a guide and see what is going on. I am monitoring all of them on mine, as I use eth1 and br0/wlan0
If you are only using WiFi, then I would expect eth1 to have virtually no traffic.
I would set up monitoring on br0 as well for a while using my how-to as a guide and see what is going on. I am monitoring all of them on mine, as I use eth1 and br0/wlan0