Page 1 of 1
Mounting the B2 on the wall
Posted: 28 Dec 2009, 15:06
by HeSitated
Is it from a technical point of view possible to mount a B2 on the wall with the connectors at the bottom?
Re: Mounting the B2 on the wall
Posted: 29 Dec 2009, 02:33
by RandomUsername
I don't see why not.
I'm not in front of my B2 at the moment and can't remember if it has any cooling vents but presumably if it has any they're only at the back so it should be fine.
Hard drives can by positioned at any angle so there's no problem there either.
Just make sure it's securely mounted
Re: Mounting the B2 on the wall
Posted: 29 Dec 2009, 14:52
by HeSitated
RandomUsername wrote:I don't see why not.
Me either, but better safe then sorry....
RandomUsername wrote:....and can't remember if it has any cooling vents
It hasn't, that's why i bould it in the first place...
RandomUsername wrote:Just make sure it's securely mounted
Hmm, now you mention it.....
Re: Mounting the B2 on the wall
Posted: 29 Dec 2009, 16:10
by johannes
Yes, should be no problems mounting it on the wall, as long as you don't put it with connectors upwards. (This since the glue keeping the front sheet plate in place _might_ not cope with the long-term stress of holding the entire bubba interiors weight).
Share a picture when you are done if you can!