forum.excito.org

I am looking for some advice on troubleshooting my new Bubba2.

I have connected the Bubba in both the recommended configurations with the Bubba in "Server Only" mode inside my existing router and also with the Bubba connected to the Internet via the WAN port and the router connected to the LAN port with the router's DHCP etc disabled.

A cannot "see" the Bubba in either configuration.

The DHCP client list on the Router when accessed via its web interface shows no entry for the Bubba.
Nether can I ping or browse to 192.168.10.1. I'm not sure if this would be possible with my current router as the net mask is 255.255.255.0 and it will not let me change the third number of the mask...

Finally I abandoned the router and connected the Bubba to the internet via the WAN port and connected my laptop directly to the Bubba using the provided patch cable.

The laptop did not get a network connection to the Bubba using an "auto eth0" connection set up for DHCP.

I set up a manual connection with an ip in the same range as the Bubba fallback (192.168.10.99) and the laptop told me that the "wired connection" was established but I still could not ping 192.168.10.1, nor could I browse to it, nor access the internet.

I am running out of things to try so any troubleshooting tips would be appreciated.

It is worth mentioning that the blue light flashes and then stops flashing and the green light lights up on the WAN/LAN ports (the LAN port tends to glow continuously rather than flickering...)

Not sure what else I can tell you!

Thanks
George

I have now booted the Bubba2 and connected it to several different computers and run the command:
"dhclient etho" on each machine. None of the machines ever appears to get an ip address from the Bubba.

I dont know what to do now.
I tried the Excito support but after an initial suggestion to try running dhclient they have gone quiet and not replied for three days....
Can anyone else suggest anything?

Here is a sample of output from one of the machines on running dhclient:
geolaptop ~: sudo dhclient eth0
[sudo] password for george:
Internet Systems Consortium DHCP Client V3.1.1
Copyright 2004-2008 Internet Systems Consortium.
All rights reserved.
For info, please visit http://www.isc.org/sw/dhcp/

wmaster0: unknown hardware address type 801
wmaster0: unknown hardware address type 801
Listening on LPF/eth0/00:15:c5:d0:bd:cb
Sending on LPF/eth0/00:15:c5:d0:bd:cb
Sending on Socket/fallback
DHCPDISCOVER on eth0 to 255.255.255.255 port 67 interval 5
DHCPDISCOVER on eth0 to 255.255.255.255 port 67 interval 14
DHCPDISCOVER on eth0 to 255.255.255.255 port 67 interval 9
DHCPDISCOVER on eth0 to 255.255.255.255 port 67 interval 7
DHCPDISCOVER on eth0 to 255.255.255.255 port 67 interval 7
DHCPDISCOVER on eth0 to 255.255.255.255 port 67 interval 10
DHCPDISCOVER on eth0 to 255.255.255.255 port 67 interval 9
No DHCPOFFERS received.
No working leases in persistent database - sleeping.

Cheers
George

Hi George,

Please see my email reply from the support.
Also, I would like to add to this that 2 of the 3 days that we did not respond was during Saturday and Sunday.

/PA